Filter
Top Products
Black plate (25,1)
<CRD3740-A>25
1 Press AUDIO to select F-HPF or R-HPF.
Press AUDIO until F-HPF or R-HPF appears in
the display.
2 Press a to turn high pass filter on.
F-HPF: 80 or R-HPF: 80 appears in the display.
High pass filter is now on.
# To turn high pass filter off, press b.
3 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Adjusting high pass filter
attenuation slope
When the high pass filter is on, you can adjust
the continuity of sound between speaker
units.
1 Press AUDIO to select the slope setting.
Press AUDIO until F-SLP or R-SLP appears in
the display.
2 Press c or d to select slope.
Press c and 12 is displayed. Press d and 6 is
displayed.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output. For more details,
see Switching the RCA output setting on page
32.
1 Press AUDIO to select NoFAD.
When the RCA output setting is P/O :FUL, you
can select NoFAD. Press AUDIO until NoFAD
appears in the display.
2 Press a to turn non fading output on.
NoFAD:ON appears in the display. Non fading
output is now on.
# To turn non fading output off, press b.
Adjusting non fading output level
When the non fading output is on, you can ad-
just the level of non fading output.
1 Press AUDIO to select non fading out-
put setting.
Press AUDIO until NoFAD: 0 appears in the
display.
2 Press a or b to adjust the level of the
non fading output.
Each press of a or b increases or decreases
the level of the non fading output (e.g., +6
24).
Press a or b until you see the desired value
displayed.
Audio Adjustments
En
25
English
Section
07
HHHHHHHHHHHHHH