Filter
Top Products
Black plate (32,1)
<CRD3740-A>32
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530 1,640
kHz allowable).
1 Press FUNCTION to select AM.
Press FUNCTION repeatedly until AM appears
in the display.
2 Press c or d to select the AM tuning
step.
Pressing c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select WARN.
Press FUNCTION repeatedly until WARN ap-
pears in the display.
2 Press a or b to turn WARN on or off.
Pressing a or b will turn WARN on or off and
that status will be displayed (e.g.,
WARN :ON).
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX :ON).
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can switch dimmer on or off.
1 Press FUNCTION to select Dim.
Press FUNCTION repeatedly until Dim ap-
pears in the display.
2 Press a or b to turn Dim on or off.
Pressing a or b will turn Dim on or off and
that status will be displayed (e.g.,
Dim :ON).
Switching the RCA output
setting
This units RCA output can be used for sub-
woofer. You can select whether to use the sub-
woofer control (low pass filter) built-in
P/O :S/W or the auxiliary P/O :FUL.
1 Press FUNCTION to select P/O.
Press FUNCTION repeatedly until P/O appears
in the display.
Initial Settings
En
32
Section
09
HHHHHHHHHHHHHH