Filter
Top Products
Installation
29
Follow these detailed cable installation instructions:
Feed the antenna cable underneath the rubber weather stripping of the rear
tailgate window/door and route the cable along the rear hatch. Lift the weather
stripping from the opening and tuck the cable inside it, then replace the weather
stripping. Pull the cable out from weather stripping and route it into the cabin
under the interior trim. Avoid hinges or gears that could crimp or cut the cable.
Route the cable through the SUV’s main cabin area under the interior trim, towards
the front of the vehicle. Use a plastic putty knife to lift the plastic trim just enough
to tuck the cable under underneath. Avoid side airbag locations on back pillars and
above the doors. (Airbag locations are marked with “SRS” logos.) Be careful not to
crimp or cut the cable.
1.
2.
1. Feed Cable Under
Rubber Seal Around
Hatch Opening
3. Route Cable
Under Carpet
to Dashboard
4. Bring Cable Out To
SIRIUS
Receiver
Location
2. Route Cable Under Interior
Trim, into Cabin and
Towards Front of Vehicle
ANTENNA
Figure 13