Filter
Top Products
Installing the Input Adaptor / Removing the Connector Cover
18
Installing the Input
Adaptor
Before installing the input adaptor, disconnect the power
cord.
1
Remove the panel of the optional input slot.
2
Insert the input adaptor into the slot.
3
Tighten the screws.
Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE
connector and the SERIAL REMOTE connector (RJ-
45).
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
1
Remove the screw of the connector cover.
2
Remove the connector cover.
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
This connector is designed to allow direct contact with
conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching this connector accidentally, attach the
connector cover when the connector is not being used to
connect to other devices.
Connector cover