Filter
Top Products
10
CONNECTIONS
Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left)
to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit.
CONNECTING AUDIO/VIDEO SOURCE EQUIPMENT TO THIS UNIT
For connections with audio/video units, use RCA type pin plug cables with the exception described later.
* If you have YAMAHA audio/video units numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily only by
connecting the output (or input) terminals of each unit to the same-numbered terminals of this unit.
MAIN
FRONT
LD
VIDEO S VIDEO
TV/DBS
IN
VCR 1
OUT
IN
VCR 2
OUT
IN
DVD/
VCR 3
OUT
MONITOR
OUT
DVD/VCR 3 OUT
CAN BE USED AS A SECOND
MONITOR OUT, IF SELECTED
BY SET MENU.
VIDEO SIGNALAUDIO SIGNALAUDIO SIGNAL
GND
PHONO
1
CD
2
TUNER
3
PLAY
4
REC
MD/TAPE 1
3
PLAY
4
REC
TAPE 2
EXTERNAL DECODER INPUT
MAIN
SUB
WOOFER
CENTER
SURROUND
CD
TV/DBS
DVD/
VCR 3
COAXIAL
OPTICAL
CD
PLAY
REC
MD/TAPE 1
LD
TV/DBS
DVD/
VCR 3
DIGITAL SIGNAL
PAL NTSC
OUTPUT
GND
OUTPUT
OUTPUT
LINE OUT
LINE IN
LINE OUT
LINE IN
LD
DIGITAL
(AC-3) RF SIGNAL
(General model)
Tuner
Turntable
MD recorder,
Tape deck 1, etc.
CD player
Tape deck 2
BASIC CONNECTIONS (for Audio Units)
GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
*
1
:
*
1