Filter
Top Products
74
SYMPTOM
The remote control transmitter does not
work.
The remote control transmitter does not
function properly.
Learning cannot be made successfully.
(The TRANSMIT/LEARN indicator does not
light up or flash.)
Continuous functions such as volume are
learned, but operate only for a moment
before stopping.
CAUSE
The batteries of this remote control
transmitters are weak.
The internal microcomputer “freezes”.
Wrong distance or angle.
Direct sunlight or lighting (of an inverter type
of fluorescent lamp etc.) is striking the remote
control sensor of the main unit.
The internal microcomputer “freezes”.
The batteries of this remote control
transmitter and/or the other remote control
transmitter are weak.
The distance between the two remote control
transmitters is too long or too short.
The signal coding or modulation of the other
remote control transmitter is not compatible
with this remote control transmitter.
Memory capacity is full.
The internal microcomputer “freezes”.
Learning process incomplete.
REMEDY
Replace the batteries with new ones and
press the RESET button on the remote
control transmitter.
Press the RESET button on the remote
control transmitter.
The remote control transmitter will function
from a maximum range of 6 meters, no more
than 30 degrees off-axis from the front panel.
Change position of the main unit.
Press the RESET button on the remote
control transmitter.
Replace the batteries (and press the RESET
button for this remote control transmitter).
Place the remote control transmitters with the
proper distance.
Learning is not possible.
Further learning is not possible without
deleting unnecessary commands.
Press the RESET button on the remote
control transmitter.
Be sure to press and hold the function key on
the other remote control transmitter until the
TRANSMIT/LEARN indicator begins flashing
slowly.
Remote control transmitter
SYMPTOM
DSP parameters and some other settings
on this unit cannot be changed.
“INPUT DATA ERROR” appears on the
display and no sound is heard.
The sound field cannot be recorded.
This unit do not operate properly.
A source cannot be recorded by a tape
deck or VCR connected to this unit.
Noise from nearby TV or tuner.
The sound is degraded when listening with
the headphones connected to the compact
disc player or tape deck that are connected
with this unit.
CAUSE
The function “9. MEMORY GUARD” in the
SET MENU mode is set to the “ON” position.
A nonstandardized source is played back, or
the unit playing back a source is
misoperating.
It is not possible to record the sound field on
a tape deck connected to this unit’s
MD/TAPE 1 REC terminals.
The internal microcomputer has been frozen
by an external electric shock (lightning,
excessive static electricity, etc.) or power
supply with low voltage.
The source unit is connected to this unit
between digital terminals only.
This unit is too close to the affected
equipment.
This unit is in the standby mode.
REMEDY
Set to the “OFF” position.
Check the source, or turn off the unit playing
back the source and then turn on again.
Unplug the AC power cord from the wall AC
outlet, and then plug in again after about one
minute.
Make additional connection between analog
terminals.
Move the unit further away from the affected
equipment.
Turn the power to this unit on.