Filter
Top Products
70
LEARNING A NEW FUNCTION
1 Place this remote control transmitter and the other
remote control transmitter so that they face each other.
2
* If there is no operation for about 30 seconds after the
LEARN button is pressed, the TRANSMIT/LEARN indicator
flashes rapidly and the current mode is canceled. If this
occurs, repeat this step.
3 If necessary, select the memory area by using the A/B/C
switch on the side panel of the remote control
transmitter.
4 Press the key on this remote control transmitter in which
you will store a new function.
* If a key which cannot learn another function is pressed, the
TRANSMIT/LEARN indicator flashes rapidly and the current
mode is canceled. If this occurs, repeat this step.
* If there is no operation for about 30 seconds after a key is
pressed, the TRANSMIT/LEARN indicator flashes rapidly
and the mode before you began learning operations is
restored. If this occurs, restart from step 2.
5 Press and hold the key (on the other remote control
transmitter) which has the function you want to store.
When learning is finished, the TRANSMIT/LEARN indicator
stops lighting. You can release the key. Then the indicator
begins flashing slowly.
* If a signal is not successfully received, the
TRANSMIT/LEARN indicator flashes rapidly and the mode
prior to step 4 is restored. If this occurs, restart from step 4.
* If memory capacity is full, the TRANSMIT/LEARN indicator
flashes rapidly to show you that learning is impossible, and
then the mode before you began learning operations is
restored.
6 Repeat step 3–5 to store more functions.
7 When you finish the learning operation, press the
LEARN button.
Notes
●
Newly learned functions will replace previously learned
functions.
●
If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash
rapidly. In this case, even if some keys are not occupied
with functions from other remote control transmitters, no
further learning is possible.
●
If you close the lid while learning, and then about 5 seconds
pass, the TRANSMIT/LEARN indicator flashes rapidly and
the mode before beginning learning operations is restored. If
this occurs, restart from step 2. However, if you open the lid
within 5 seconds, the mode before closing the lid is
restored.
●
There may occasionally be instances in which, due to the
signal-coding and modulation employed by the other remote
control transmitter, this remote control transmitter will not be
able to “learn” its signals.
●
When you press the LEARN, MACRO or CLEAR button, or
the RESET button inside of the battery compartment by
using a sharp-pointed thing, be careful not to damage the
button. If you will use a mechanical pencil, make sure that
the lead is not coming out.
V-AUX
PHONO
EFFECT
ON/OFF
1 2 3
SPORTS
STADIUM
DISCO
TV
4 5 6
ROCK
JAZZ CLUB
CHURCH
7 8 9
L
L
TEST
E
+10
Lights up.
V-AUX
PHONO
EFFECT
ON/OFF
1 2 3
ORTS
STADIUM
DISCO
TV
5 6
Z CLUB
CHURCH
9
EST
This remote control
transmitter
Other remote
control transmitter
About 5–10 cm
(2–4 in.)
TRANSMIT
/LEARN
LEARNCLEAR MACRO
Flashes slowly.
(Press by using the point of
a mechanical pencil, etc.)
LEARNCLEAR MACRO
V-AUX
PHONO
EFFECT
ON/OFF
1 2 3
SPORTS
STADIUM
DISCO
TV
4 5 6
OCK
JAZZ CLUB
CHURCH
8 9
TEST
10