3-17
ISM 824 Integration Scaling Multiswitcher • Operation and Setup
4. Press the Video button to exit RGB delay mode. The Video button ceases
ashing, and remains lit green, and the Audio button lights red. The View,
Esc, and output buttons extinguish.
N
Alternatively, pressing Enter or Preset exits the RGB delay mode.
Changing the RGB delay
To change the RGB delay, do the following:
1. Press Esc to clear all pending changes and reset the LCD.
2. Press and hold the Video button for 3 seconds, until it ashes green. The
View, Esc, and one output button lights green, and the LCD shows the RGB
delay for the indicated (lit) output.
N
The output button that lights is the last output button pressed in the previous
front panel operation made just prior to this RGB viewing.
3. Select the desired output button, and observe the LCD screen.
4. Use the View and Esc buttons to increase or decrease the RGB delay in
0.1 second steps until the desired setting is reached (see figure 3-24).
N
Alternatively, either of the front panel encoders can be used to increase or
decrease the RGB delay to the desired setting (see figure 3-24).
PRESET
ENTER
ESCVIEW
PRESET
ENTER
ESCVIEW
Step 4.
Press the Esc button
to increase the RGB delay by
0.1 second increments.
Press the View button to
decrease the RGB delay by
0.1 second decrements.
Out
#3 RGB Delay
N The LCD shows the new
RGB delay setting for the
selected output.
1.2 Seconds
ADJUST
Alternatively, rotate either of the front panel
encoders to increase or decrease the
RGB delay by 0.1 second intervals.
or
Figure 3-24 — Steps 4 for setting the RGB delay
5. Press the Video button to exit the RGB delay display and adjust mode. The
Video button ceases ashing, and remains lit green. The Audio button lights
red, and the View, Esc, and output buttons extinguish. The LCD resets.
N
The RGB interval is stored in non-volatile memory. When power is removed
and restored, the RGB delay settings are retained.
