A SERVICE OF

logo

Open as PDF
next previous
3-37
ISM 824 Integration Scaling Multiswitcher • Operation and Setup
Figure 3-48 — Output configuration menu for Video Scaler card
Default
Cycle
Menu
Menu
Menu
Menu
Auto
Image
Output Card
Configuration
Next
Menu
30 sec.
Select Output
#8 Video Scaler
NOTE When entering the first submenu, Select Output, the last selected scaler card output button and
its associated input button lights green, and the LCD indicates the selected output. If another
output is desired, press that output button, or rotate either front panel encoder to select it.
Input
Configuration
View Comm
Settings
Menu
Next
Menu
30
sec.
30
sec.
30
sec.
30
sec.
30
sec.
30
sec.
30
sec.
30
sec.
Output Config
#8 Video Scaler
RGBHV
Output Type
Rotate encoder to
adjust pixel value
Rotate encoder to
adjust refresh rate
Next
H - V -
Sync Polarity
Next
Rotate either encoder
to change sync polarity
1024x768 60
Resolution
Next
Rotate either encoder
to select output type
(RGBHV, RGBS,
RGsB, YUV Bi-Level)
Next
30
sec.
30
sec.
30
sec.
Menu
Next
User Presets
#8 Video Scaler
30 sec.
<NA> 1 2 3
Save Preset
Next
Rotate either encoder
to select a preset to
save current settings
<NA> 1 2 3
Erase Preset
Next
Rotate either encoder
to select a preset
to erase
Advanced Config
#8 Video Scaler
30 sec.
Menu
Next
Video Scaler Output Card Configuration submenus
NOTE Within any sub menu, press the Menu button to go directly to the top level (Output Card Configuration) menu.
000 000
Top Blanking Bot
Next
Rotate either encoder
to adjust top and
bottom blanking area
<Off> On
Blue Mode
Next
30
sec.
Off <On>
Filter
Next
Rotate either encoder
to turn encoder filter
On or Off
30
sec.
30
sec.
Off <On>
2:2 Pulldown
Next
Rotate either encoder
to turn 2:2 Pulldown
On or Off
30
sec.
<Off> On
Enhanced Mode
Next
Rotate either encoder
to turn enhanced mode
On or Off
Auto Memories
Next
Rotate either encoder
to turn auto memories
On or Off
Off <On>
Rotate encoder to
select input
Rotate encoder to
turn On or Off
Input #2 On
Auto Image
System Reset
Menu
Rotate either encoder
to turn Blue Mode
On or Off
30
sec.
Video Scaler conguration menu
To congure the Video Scaler card using the Output Card Conguration menus (see
figure 3-48), follow the steps in each submenu shown below.
The Output Card Conguration submenus for the Video Scaler card are:
Select Output, Output Cong., User Presets, and Advanced Cong.
N
Within any submenu, press the Menu button to go directly to the top level
(Output Card Configuration) menu.
N
If no front panel buttons or encoders are used for 30 seconds, the device times
out and goes back to the default display cycle.