A SERVICE OF

logo

Open as PDF
next previous
Matrix Software, cont’d
CrossPoint / MAV Matrix Switchers • Matrix Software
5-4
Using the Matrix Switcher Control software
ManyitemsfoundintheMatrixSwitchersControlProgramarealsoaccessible
viafrontpanelcontrols(seechapter3,”Operation”)andunderSIScontrol(see
chapter4,“Programmer’sGuide”).TheMatrixSwitcher+HelpProgramprovides
information on settings and on how to use the control program, itself.
1. ToruntheMatrixSwitchersControlProgram,clickStart>
Programs>Extron Electronics>Matrix Switchers>
MATRIX Switcher + Control Pgm.
TheCommPortSelectionwindow(gure5-3)appears.
Figure 5-3 — Comm port selection window
2. ChoosethecommportthatisconnectedtotheCrossPointorMAVswitcher’s
rear panel Remote port or to the front panel Config port (matrix sizes up to
1616),IP [LAN], or Emulate.
If you selected a comm port, check the baud rate
displayedinthecommportselectionwindow.Ifyou
need to change the baud rate, click on the Baud button
and double-click on the desired baud rate.
Availableratesare9600,19200,38400,and115200.The
defaultis9600.
Click OK and proceed to step 4.
• If you selected IP [LAN], click OK and proceed to step 3.
• If you selected Emulate, click OKandsee“UsingEmulationmode”on
page 5-23.
3. If you selected IP [LAN] in step 2,theIPConnectionwindowappears
(gure5-4).
Figure 5-4 — Address and password entry