A SERVICE OF

logo

Open as PDF
next previous
3-13
CrossPoint / MAV Matrix Switchers • Operation
Creating a configuration
The current configuration can be changed using the front panel buttons. Change
the current configuration as follows:
1. PresstheEscbuttontoclearanyinputbuttonindicators,outputbutton
indicators, or control button indicators that may be lit.
2. Selecttocongurevideo,audio,orbothbypressingtheRGBHV
(CrossPointswitchers)orVideo(MAVPlusswitchers)buttonand/orAudio
button.
3. Selectthedesiredinputandoutput(s)bypressingtheinputandoutput
buttons.
• Inputbuttonslightamber(matrixsizesupto1616)orgreen (matrix sizes
above1616).Outputbuttonslightorblinkoneofthefollowingcolors:
Amber to indicate video and audio ties
Green to indicate video only ties
Red to indicate audio only ties.
• To indicate potential ties, output buttons blink the appropriate color
when an input is selected.
• To indicate current ties, output buttons light steadily the appropriate
color when an input is selected.
• To clear unwanted outputs, press and release the associated lit output
buttons. To indicate potential unties, output buttons blink the
appropriate color when an output is deselected but not untied from the
input.
4. PressandreleasetheEnterbuttontoacceptthetieortobreakanexistingtie.
5. Repeat steps 1 through 4 to create or clear additional ties until the desired
configuration is complete.
N • Onlyonevideoinputandoneaudioinputcanbetiedtoanoutput.
• Ifatieismadebetweenaninputandanoutput,andtheselectedoutputwas
previously tied to another input, the older tie is broken in favor of the newer
tie.
• Ifaninputwithnotieisselected,onlythatinput’sbuttonlights.
• WhentheWhen the RGBHV (CrossPoint switchers) or Video (MAV Plus
switchers) button and Audio button are lit, if an input with an audio tie but
no video tie is selected, the input’s button lights amber (matrix sizes up to
1616) or green (matrix sizes 3232 and above) and the output button lights
the appropriate color (amber, green, or red).
• Aseachinputandoutputisselected,theassociatedoutputbuttonblinksthe
appropriate color to indicate a tentative tie. Buttons for output(s) that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off
by pressing the associated output button.
• IfyoupresstheinputbuttonforanI/Ogroupedinputandthentrytoselect
an output in a different group, you cannot select the associated output button
(the action is ignored). The associated input button remains lit.