A SERVICE OF

logo

Open as PDF
next previous
Operation, cont’d
CrossPoint / MAV Matrix Switchers • Operation
3-6
Control buttons
Primary functions
Action:
Savechanges SelectPreset mode SelectView mode Cancel/escape
Indication:
Blink: save needed Blink:Savepreset
Lit: Recall preset
View mode selected Flashes once
ENTER
PRESET
VIEW
ESC
Secondary functions
I/O Grouping Action/
indication:
Selectgroup1. Selectgroup2. Selectgroup3. Selectgroup4.
Port
conguration
Action 1:
SelectConfiguration mode
Action 2/
indication:
Select9600baud.
Blink: selected
Select19200baud.
Blink: selected
Select38400baud.
Blink: selected
Select115200baud.
Blink: selected
Front panel
locks
Action:
With Video and
Audio, select Lock
mode2and/or
toggle between
mode0andmode2.
RGB delay Action:
CrossPoint:
InRGB Delay
mode, decrease the
switching interval.
InRGB Delay
mode, increase the
switching interval.
Audio Action:
InAudio mode,
decrease input level
or output volume.
InAudio mode,
increase input level
or output volume.
c
Enter button — TheEnterbuttonhastwoprimaryfunctions(•)andfour
secondary functions (❏):
• Savecongurationorpresetchangesthatyoumakeonthefrontpanel.
To create a simple configuration:
SpecifyRGBHV(CrossPointswitchers)orvideo(MAVPlus
switchers),audio,orboth(seeI/Oselectionbuttons[
g
]and[
h
]).
Pressthedesiredinputbutton(
a
).
Pressthedesiredoutputbutton(s)(
b
).
PresstheEnterbutton.
• Indicatethatapotentialtiehasbeencreatedbutnotsaved.
❏ IntheI/O Groupmode,selectgroup1andindicatetheselection.See
“I/Ogrouping”onpage3-24.
❏ WiththePreset,View,andEscbuttons,selectSerial Port Selection and
Configurationmode.See“SelectingtherearpanelRemoteportprotocol
andbaudrate”onpage3-54.
❏ Select9600baudfortherearpanelRS-232/RS-422portinSerial Port
Selection and Configurationmodeandindicatetheselection.See“Selecting
therearpanelRemoteportprotocolandbaudrate”onpage3-54.
❏ WiththeRGBHV/VideoandAudiobuttons,selectfrontpanelsecurity
Lockmode2ortogglebetweenmode0(unlocked)andmode2.See
“Settingthefrontpanellocks(Executivemodes)”onpage3-52.