A SERVICE OF

logo

COOLING SYSTEM 4-15
Thermostat
Thermostat Removal
Drain the coolant (see Cooling System in the Periodic
Maintenance chapter).
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Thermostat Bracket Bolt [A]
Ground Lead [B]
Water Temperature Sensor Connector [C]
Three Water Hoses [D]
Remove the thermostat housing [E].
Remove the screws [A], take off the cap [B], and take out
the thermostat.
Thermostat Installation
Install the thermostat [A] in the housing so that the air
bleeder hole [B] is on top.
Install a new O-ring into the housing.
Fill the radiator with coolant (see Cooling System in the
Periodic Maintenance chapter).
Thermostat Inspection
Remove the thermostat, and inspect the thermostat valve
[A] at room temperature.
If the valve is open, replace the thermostat with a new
one.