A SERVICE OF

logo

Open as PDF
next previous
5: Commands and Levels
IntelliBox-I/O 2100 Command Reference 71
command mode echo serial string disable
Disables user-defined serial boot string to be echoed in
the CLI.
command mode echo serial string enable
Enables user-defined serial boot string to be echoed in the
CLI.
command mode serial string
Enables user to enter a custom string at boot time to enter
command mode.
command mode serial string <string>
Sets a string that can be entered at boot time to enter
command mode.
command mode serial string binary <string>
Sets a binary string that can be entered at boot time to
enter command mode.
command mode signon message <string>
Sets an ASCII sign-on message that is sent from the seri-
al port when the
command mode signon message binary <string>
Sets a binary sign-on message that is sent from the serial
port when the
command mode wait time <milliseconds>
Sets boot-up wait time for command mode serial string.
data bits 7
Uses seven bits for data on the line.
data bits 8
Uses eight bits for data on the line.
default baud rate
Restores the default speed of 9600 bits per second.
default data bits
Restores the default of eight data bits.
default flow control
Restores the default of no flow control.
default interface
Restores the default interface type to this line.
default parity
Restores the default of no parity.
default protocol
Restores the default protocol on the line.
default stop bits
Restores the default of one stop bit.
default xoff char
Restores the default xoff character on this line.
default xon char
Restores the default xon character on this line.
exit
Exits to the enable level
flow control hardware
Uses hardware (RTS/CTS) flow control on the line.
flow control none
Does not provide flow control on the line.
flow control software
Uses software (xon/xoff characters) flow control on the
line.
interface rs232
Sets the line interface to RS232.
interface rs485 full-duplex
Sets the line interface to RS485 in full-duplex mode.
interface rs485 half-duplex
Sets the line interface to RS485 in half-duplex mode.
line
<line>
Enters the line level.
lpd
<line>
Enters the configure lpd level.
name <text>
Sets the name for this line.
no clear line counters
Restores the serial counters to the aggregate values.
no command mode
Disables command mode for the current line.
no command mode serial string
Prevents the user-defined serial boot string from being
used to enter
no command mode signon message Clears the signon message displayed at boot time and
when entering
no name
Removes the name of this line.
parity even
Uses a parity bit on the line for even parity.
parity none
Does not use a parity bit on the line.
parity odd
Uses a parity bit on the line for odd parity.
protocol lpd
Applies Line Printer Daemon (LPD) protocol on the line.