5: Commands and Levels
IntelliBox-I/O 2100 Command Reference 72
Applies LPD or tunnel protocol on the line.
Applies Modbus ASCII protocol on the line.
Applies Modbus RTU protocol on the line.
Uses no protocol on the line.
Applies tunnel protocol on the line.
Asserts line status with current configured values.
Displays the current status.
Shows the command mode settings for the current line.
show history
Displays the last 20 commands entered during the current
CLI session.
Displays the current configuration.
Shows the line statistics.
Disables the line so data cannot be sent/received.
Enables the line so data can be sent/received.
Uses one stop bit after data on the line.
Uses two stop bits after data on the line.
Enters the configure-terminal level.
Enters the configure-terminal level for the network.
Refrains from terminating the line.
termination enable Enables 120 ohm line termination in RS485 half-duplex
Stores the current configuration in permanent memory.
xoff char <control>
Sets the xoff character for use with software flow control
Sets the xon character for use with software flow control
on this line.
link (config-ethernet:eth0) level commands
Restores the default duplex setting, which is auto.
Restores the default speed setting, which is auto-
negotiate.
Sets duplex mode to auto.
Sets duplex mode to full.
Sets duplex mode to half.
Exit back to interface configuration level
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Sets the speed of the Ethernet link to 10 Mbps.
Sets the speed of the Ethernet link to 100 Mbps.
Sets the speed of the Ethernet link to auto-negotiate.
Stores the current configuration in permanent memory.
Continuously displays lpd status for the specified line.
Exits to the enable level.
