1.16
Getting started
EasyStart software is already installed on your Muratec machine. It guides you
through the process of entering your machine’s settings.
Remember that the settings you make here can always be changed later.
Getting started
Determine the following before you go any further:
The name and fax number you want to appear on your faxes —
Every fax page you send arrives at the receiving machine with a single line of text
at the very top of the page. This text lists a name and a fax number, which are
called a Transmit Terminal Identifier (
TTI
). The
TTI
cannot be longer than 22 char-
acters.
Clearing stored settings
Before using EasyStart, clear your machine’s built-in user data memory. This
ensures the memory will hold only your settings.
Important: After you use EasyStart, do not clear the memory again unless an
authorised technician asks you to do so.
To clear the machine’s memory:
1
Press
MENU
,*,2.The
LCD
now asks if you want
to clear the memory.
Note: If you don’t want to clear the memory,
just press [Cancel].
2
If you do want to clear the memory, press
[Enter].
Entering initial settings
Important: If you press
STOP
during EasyStart, your machine returns to standby
mode (its normal condition). But it will keep the settings you saved by
pressing [Enter] as described in these instructions.
1
Press
FAX
to change to Fax mode, if the machine is in Copy mode.
2
Press
MENU
, [Fax Set],
I
, [Enter].
The
LCD
shows the current calendar/clock setting, with a cursor appearing
under the first digit.
3
Use the numeric keypad to enter the correct
date and time, using a 24-hour format for the
time. For instance, to set 1:30
PM
on July 4,
2000, press 2 0 0 0 0 7 0 4 1 3 3 0.
Note: Your machine automatically inserts the
spaces and date-slash. All you have to
do is enter the digits.
To change a digit, press the cursor key to move the cursor. Then enter the cor-
rect digit.
4
Press [Enter] to save the clock setting and continue EasyStart.
5
The
LCD
now asks you to enter your fax number
as you want it to appear on other fax machines’
displays or printouts. The fax industry term for
this number is Subscriber
ID
.
6
Use the numeric keypad to enter the fax num-
ber. To insert a dash, as shown here, press [ – ].
The number may contain up to 20 characters (numbers and dashes).
Note: If you make a mistake, press [Clear] to erase to the left.
To change just one number, move the cursor by cursor key. Press
[Clear] to erase the number. Then re-enter the fax number correctly.
7
Press [Enter] to save the number and continue.
EasyStart
