1.19
Getting started
The following is a basic fax features. If you want to use one-touch keys or any other
advanced features, See “Fax Reference”.
Sending a fax
1
Press
FAX
to change to the Fax mode, if it is in Copy mode.
2
Set the document(s) in
ADF
or
FBS
.
3
Adjust resolution and contrast, if necessary.
Press
RESOLUTION
to change the resolution.
Press
CONTRAST
to change the contrast.
4
Adjust memory transmission, if necessary.
Press
MEMORY TRANSMISSION
to toggle memory transmission on and off.
5
Enter the fax number.
6
Press
START
.
If you use
FBS
, press [Exit] after scanning is finished.
Important: If you want to cancel a transmission while scanning the docu-
ment, press
STOP
.
If you want to cancel a transmission in progress, use the Review
Commands function. See “Review Commands” next.
Review Commands
The Review Commands function gives you the power to check on each job (or
command) in your machine’s memory. It also lets you cancel a command if you
decide not to send the document.
To cancel a command:
1
Press
REVIEW COMMANDS
.
2
Select the command you want to cancel by cursor key.
3
Press [Cancel].
Note: If you want to stop reviewing the stored commands, press
RESET
to
return the machine to standby mode.
For more information on the Review Commands function, see page 2.11 in “Fax
Reference”.
Receiving a fax
A received fax is printed automatically even when the machine is in Copy mode or
Auto power off mode.
Your machine has five different reception modes — Tel Ready, Fax Ready, Fax/Tel
Ready, Tel/Fax Ready and Ans/Fax Ready. Your machine is set to Fax Ready mode
for default. If you want to change the reception mode, see pages 1.12-1.13 in “Fax
Reference”. We’ll explain each of these and the operation of how to set the reception
mode in that page.
Using as a Fax
