Just in case …
2.3
Printer cover / Fuser cover
When the printer cover or the fuser cover part is blinking on
LCD
:
1
Open the printer cover by holding the
printer cover release.
Important: Never touch the electrical contacts inside the printer cover and
under the drum cartridge, as an electrostatic discharge may
damage the machine.
2
When the printer cover part is blink-
ing on
LCD
, remove the jammed
paper, then skip to step 6.
When the fuser cover part is blinking
on
LCD
, proceed to step 3.
Note: Do not remove the dram car-
tridge at this time.
3
Open the fuser cover.
CAUTION:
The fuser unit becomes very
hot. Do not touch the fuser
unit when you are removing a
paper jam.
4
Pull the paper jam clear lever toward
you and remove the jammed paper.
5
Push the paper jam clear lever back into its normal position and close the
fuser cover.
6
Close the printer cover.
