Just in case …
2.1
If an original document jams
1
If an original document jams, the
LCD
will
show:
Important: If you wait more than 60 seconds
without pressing any key, the
machine will delete from memory
all pages stored during this oper-
ation and the machine will return to the standby mode.
Note: If this document is a non-sorting
ADF
job (either copying or faxing), the
machine will abort the operation anyway; instead, you’ll have to per-
form the job again from scratch.
Note: In Quick memory transmission, the check message will be printed,
which has the number of jammed page. Reset the jammed documents
and transmit it.
2
To continue scanning from the jammed page,
press [Yes].
Note: If you press [No], only scanned pages
before the paper jam occurred will be
transmitted or copied.
Note: If you wish to cancel this operation,
press stop. The machine will delete all pages from memory and then
return to its standby mode.
3
Reset the documents from the jammed page and press
START
.
To remove the document:
1
Open the
ADF
cover by holding the
ADF
cover release.
2
Remove the original document from the
machine. Then skip to step 5.
If you cannot remove the original docu-
ment, proceed to step 3.
3
Open the inner cover as shown at right,
then remove the document. Then skip
to step 5.
If you cannot remove the original docu-
ment, proceed to step 4.
4
Lift the document tray as shown at
right, then remove the document.
5
Gently close the inner cover and the
ADF
cover, making sure both sides are
snapped down securely.
Note: If the original document has
become wrinkled or torn, do not
re-send it.
Clearing paper jams
