Installation
3-1
Part 1061253B
E 2006 Nordson Corporation
Section 3
Installation
WARNING: Allow only qualified personnel
to perform the following tasks. Follow the
safety instructions in this document and all
other related documentation.
Inspection and Packaging
The Nordson CoolWave system has been carefully
tested, inspected, and packaged prior to shipping.
Upon receipt, inspect the shipping materials and
components for visible damage. Report any
damage immediately to the shipper and to the
Nordson UV systems engineering department.
NOTE: When opening the packaging, please take
care so that the packaging can be re-used to ship
the unit to the next destination. Keep all packaging
materials together and in a location where they will
not get damaged.
Mounting Guidelines
Power Supply
WARNING: Heavy equipment. Be careful
when moving the unit.
See Figure 3-1 for power supply dimensions and
clearance requirements.
S The power supply can be mounted on any
horizontal surface.
S Power supplies can be stacked up to five units
high but due to the weight of each unit
(approximately 230 lb) it is recommended that
they be stacked so they can be easily accessed
for service.
S Leave at least six inches of ventilation
clearance on all four sides of the power supply
unit.
S Blowers are mounted on the front and the rear
of the power supply and need to be free and
clear of any obstructions.
1500112A
(29.65 in)
753.00 mm
(6 in)
152 mm
(17.83 in)
452.80 mm
(18.33 in)
465.50 mm
Ventilation
Clearance
on all Four Sides
(10.09 in)
256.30 mm
Figure 3-1 Power Supply Dimensions
