A SERVICE OF

logo

Installation
3-10
Part 1061253B
E 2006 Nordson Corporation
Main Control Board
Standard Configurations
See Figures 3-6 and 3-7.
The following information identifies the standard
switch configurations for the power supply unit.
The systems may be configured to run as
standalone or interconnected to form a complete
networked system of up to 16 lamps.
1500117A
3
1
2
DISPL OR LED
REM CFG Y/N
FRT PNL LOCK Y/N
RF DET Y/N
FAULT UNIT/ALL
REM ANALG Y/N
2
OPEN
4
LIGHT DET
CAN CTRL
NOT USED
NOT USED
NOT USED
CAN/485
OPEN
5
SW1 SW3
Figure 3-6 Main Control Board
1. Main control board
2. Dip switches
3. Power supply address switch
4. Digital/Analog jumper (light
detector) (See Note)
5. 4-20 ma/0-10 Vdc jumper
Note: Digital/Analog jumper for light detector set to Digital for all single lamphead cable units.
1500063B
3
1 2
LAMP 6“/10”
REM ANALG EN/DIS
LOC LKOUT/NORMAL
FAULT ALL/UNIT
NONE/RE DET
SLAVE/MASTER
2
OPEN
4
Figure 3-7 Main Control Board Manufactured before August 2004
1. Main control board
2. Dip switches
3. Power supply address switch 4. 4-2 ma/0-10 Vdc Jumper