Operation
4-8
Part 1061253B
E 2006 Nordson Corporation
Locally Operated Units (contd)
Step Single Unit
Operated Locally
Multiple Units Networked to a Master Unit
Operated Locally
7 Start up the lampheads.
NOTE: If the LAMPON message does not appear, refer to the Troubleshooting section.
Rapid Startup
Use this procedure if your system will sit in an idle state in the STDBY mode before
moving to the On mode.
1. On the LAMP selector (or master control unit’s LAMP selector) press the LAMP
Standby button. There will be an approximate 10 second warm-up time for the
filament transformer. WARMUP will appear on the display.
2. After approximately 10 seconds the system will display STDBY until Lamp On is
pressed.
3. Press the LAMP On button. It will take approximately eight seconds to stabilize.
Or
Standard Startup
Use this procedure to go directly through the warm-up to the On mode.
1. On the LAMP selector (or master control unit’s LAMP selector) press LAMP On.
WARMUP will appear on the display.
2. After approximately 10 seconds the unit will display LMPDLY. It will take 10 seconds
to stabilize as it goes thru the warm up cycle before turning to On.
3. After approximately 10 more seconds and the unit(s) has stabilized at the set power
level, LAMPON will appear in the display and the system is ready to run.
