Chapter 13 Troubleshooting
WAP3205 v2 User’s Guide
115
5 Reset the device to its factory defaults, and try to access the WAP3205 v2 with the default IP
address. See Section 12.7 on page 110.
6 If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
Advanced Suggestion
• If your computer is connected wirelessly, use a computer that is connected to a LAN port.
I can see the Login screen, but I cannot log in to the WAP3205 v2.
1 Make sure you have entered the password correctly. The default password is 1234. This field is
case-sensitive, so make sure [Caps Lock] is not on.
2 This can happen when you fail to log out properly from your last session. Try logging in again after
5 minutes.
3 Disconnect and re-connect the power adaptor or cord to the WAP3205 v2.
4 If this does not work, you have to reset the device to its factory defaults. See Section 13.4 on page
116.
13.3 Internet Access
I cannot access the Internet.
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide.
2 Make sure the WAP3205 v2 is connected to a broadband modem or router with Internet access.
3 If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless
client are the same as the settings in the AP.
•Go to Network > Wireless LAN > General > WDS and check if the WAP3205 v2 is set to
bridge mode. Select Disable and try to connect to the Internet again.
4 Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
5 Check the switch on the WAP3205 v2’s side panel for your system operating mode setting.
•Use AP mode if your WAP3205 v2 bridges traffic between clients on the same network.
•Use CL (Client) mode if your WAP3205 v2 needs a wireless client to connect to an existing
access point.
•Use UR (Universal Repeater) mode if you want to have wireless clients associate with the
WAP3205 v2 and also want to connect the WAP3205 v2 to an existing access point.
