Chapter 10 Wireless LAN
WAP3205 v2 User’s Guide
91
10.5.4 WPA/WPA2 Authentication
Use this screen to configure and enable WPA or WPA2 authentication. Select WPA or WPA2 from
the Security Mode list.
Note: WPA or WPA2 is not available if you enable WPS before you configure WPA or WPA2
in the Wireless LAN > Security screen.
Note: If you select WPA or WPA2 for the first SSID of the WAP3205 v2 in the Wireless
LAN > Security screen, you cannot enable the WPS feature on the WAP3205 v2.
Figure 60 Network > Wireless LAN > Security: WPA/WPA2
WPA
Compatible
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your WAP3205 v2.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the WAP3205 v2.
Reset Click Reset to reload the previous configuration for this screen.
Table 34 Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
