Filter
Top Products
2-142-14
2-142-14
2-14
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installation
2.9 Installing an optical drive
The S-presso system comes with one optical drive bay. Refer to this
section to install an optical drive.
To install an optical drive:
1. Drive a screw on each side of
the optical drive as shown.
Set the optical drive jumper to Master before connecting the IDE cable
and power plug. Refer to the optical drive documentation on how to set
the optical drive jumper to Master.
4. Push the optical drive until the
hinge lock snaps the screws into
place.
2. Remove the front panel. Refer
to section “2.3 Removing the
front panel” for instructions.
3. Slide the optical drive into the
optical drive bay.