Filter
Top Products
3. Display installation
Pay attention that all cables stay in the cable channel while re-attaching the cover.
To re-attach the connector compartment cover
1. Slide the cover’s top in position and then push the cover’s bottom. You’ll hear a “click” sound of the
cover’s clips when the connector compartment cover is in position.
3.8 VESA-mount installation
WARNING: Use an arm that is approved by VESA (according to the VESA 100 mm stan-
dard).
Use an arm that can support the weight of
the display. Refer to the technical specifica-
tions of this display for the applicable weight.
CAUTION: You should mount the panel in landscape position. Portrait position is pos-
sible but not supported.
Overview
The panel, standard attached to a stand, is compatible with the VESA 100 mm standard. Thus, it can be
used with an arm that is approved by VESA. This chapter shows you how to release the panel from the
stand and how to attach it to an arm. If you’re not using an arm, you can skip this chapter.
12
K5902055 CORONIS FUSION 6MP 28/08/2013