Filter
Top Products
5. Advanced operation
5.22 Im age source selection modes
About image source selection modes
Your Coronis Fusion 6MP automatically detects the number of video input signals connected, attaches
them to the correct display side and applies the correct video settings to it (resolution, video encoding
mode, refresh rate,...). However, it may be needed to manually select the video input signal(s) to be
displayed on a certain display side or to adjust certain video settings yourself. The start to this is selecting
one of the f ollowing image source selection modes av ailable for your display:
Automatic In this mode, your display automatically detects the
connected video input signals, attaches them to the
correct display side and applies the correct video
settings to it (resolution, video encoding mode,
refresh rate,...). No video settings are available
when this mode is selected.
One Image Source This mode is intended for displaying and manually
configuring only one connected video input signal.
When selecting this mode, the video settings
become available for the selected video input
signal.
Two Image Sources This mode is intended for displaying and manually
configuring two connected video input signals (one
on each display side). When selecting this mo de,
the video settings become available for the selected
video input signal on each side of the display.
To select an image source selection mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu.
4. Select one of the available image source selec
tion modes and confirm.
5.23 Video input signals
Your Coronis Fusion 6MP display automatica
lly detects the connected video input sig-
nals. Manually selecting image source video input signals is possible, but then your
display’s i mage source s ele ction mode should be set to allow this. Please refer to "Im-
age source selection modes", page 28 to do this.
About input signals
The available input signals for yo
ur display are:
DisplayPort 1 The input corresponding to the DisplayPort 1
connector.
DVI 1 The input corresponding to the DVI 1 connector.
DisplayPort 2 The input corresponding to the DisplayPort 2
connector.
DVI 2 The input corresponding to the DVI 2 connector.
Automatic Selection
The input is automatically selected.
28 K5902055 CORONIS FUSION 6MP 28/08/2013