Filter
Top Products
55
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Removing the KeyCard
To unlock the operating panel:
• Press 1, the operating panel will fold
down forwards.
• Push the card in to the right as far as
possible and remove it to the front.
• Push the operating panel back into po-
sition.
For safety’s sake, the operating
panel must remain locked when
the vehicle is in motion.
When you leave the vehicle, un-
lock the panel and remove the
KeyCard to protect the equipment
against theft.
“Training” a second KeyCard/
Replacing a KeyCard
When the unit is in operation with the first
KeyCard, you can “train” a second one to
be also used with the set.
If you want to “train” a second KeyCard:
• Insert the first KeyCard and turn on the
set.
• Press the DSC button and press
/
to select “LEARN KC”.
• Press << or >>.
The display will switch to “CHANGE”.
KeyCard theft protection system
• Insert the KeyCard with the contacts
facing down as shown in the illustra-
tion (arrow 1).
2
1
3
• Push the card in the direction of the ar-
row (2) and lock the operating panel
back into position (arrow 3).
The car radio is now ready for operation.
If a wrong KeyCard is inserted, then “CARD
ERR” will appear in the display.
The system will switch off after approximate-
ly ten seconds.
If another card type is inserted (e.g. phone
or credit card), the display will show
“WRONG KC” for approximately two sec-
onds.
Remove the wrong card and insert the cor-
rect KeyCard.
• Press ON to turn on the set.
This car radio comes equipped with one
KeyCard, but it can also be operated with a
second card.
If you have lost your KeyCard or if it was
damaged, you can buy a new one from your
specialised dealer.
If you use two KeyCards, the settings stored
on the first card will be transmitted to the
second. However, you can individually store
the following functions:
Preset button assignments, bass, treble,
balance and fader settings, Loudness, TA
(traffic announcement volume), beep vol-
ume, LOW-EQ, HIGH-EQ.
In addition, the settings activated before the
radio is switched off, such as the waveband,
station, TA priority, AF, REG ON/OFF,
SCANTIME, seek tuning sensitivity, ON VOL
and SHARX will also remained stored.
This ensures that you will find your basic
settings re-adjusted automatically as soon
as you have inserted your KeyCard.
Putting the unit into operation
• Turn on the set with ON.
To insert the KeyCard, unlock the operating
panel by
• pressing 1, the operating panel will
fold down.
ChicHanKanMonParis gb 95%® 14.05.2002, 14:24 Uhr55