Filter
Top Products
68
This unit is equipped with a real-time
counter which calculates the current
playing time.
After a new cassette has been insert-
ed, the real-time counter will switch to
a synchronisation phase briefly. During
this time, SYNC will appear in the dis-
play. The synchronisation phase may
vary in length for ELAPSED or
REMAIN.
Track reverse
To change the track during playback:
• Press REV.
When the tape reaches the end of a side it
will automatically switch to the other side
(autoreverse). “SIDE A” will appear in the
display for track 1 and “SIDE B” for track 2.
Note:
If there is too much tension on the tape while
it is playing, it may switch to the opposite
track before it has reached the end. Check
to see if the tape is wound correctly. It often
helps to rewind the cassette completely.
Scanning cassette titles with
SCAN
It is possible to scan the titles on a cassette.
As soon as you find a title you like, you can
end SCAN. This title will then continue to
play.
SCAN is active when “SCA” is highlighted
in the display. “SCAN” will also appear in
the top line of the display.
Starting/ending SCAN:
• Press SCA briefly.
To ensure that this function works properly,
there must be a pause of at least 3 seconds
between titles.
The scan time is set to 10 seconds at the
factory and can be altered from 5 to 30 sec-
onds. If necessary, refer to the section on
“DSC programming - SCANTIME”.
Selecting titles with S-CPS
(Super Cassette Program Search)
To repeat and skip cassette titles.
/ Select title
Forwards (CPS-FF ..)
Back (CPS-FR ..)
It is possible to skip up to 9 titles. To do so,
• press
/ on the rocker switch as of-
ten as required.
The number of titles to be skipped will ap-
pear in the display.
Make any corrections by pressing the op-
posite key (
/ ).
Press REV to stop this function immediately.
To ensure that this function works properly,
there must be a pause of at least 3 seconds
between titles.
Cassette operation
ChicHanKanMonParis gb 95%® 14.05.2002, 14:25 Uhr68