Filter
Top Products
62
To select a scanned station and switch
off the Radio Scan function:
• Press SCA or the rocker switch briefly.
If you do not select a station, the scan func-
tion will automatically switch off after the fre-
quency band has been run through com-
pletely. The unit will tune into the station you
were listening to before you started the scan
function.
Changing the scan time
The scan time can be set from between five
to a maximum of 30 seconds.
Please refer to the section on “DSC pro-
gramming - SCANTIME”.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, more distant stations (high
sensitivity).
If you want to alter the sensitivity level,
please refer to the section on “DSC program-
ming - LO/DX”).
• by pressing ST1 - ST6.
To select a station on a different waveband:
• Press NEXT as often as necessary un-
til the desired memory bank appears
and then select the station by pressing
ST1 - ST6.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all wavebands and in the se-
lected FM memory bank.
Preset Scan cannot be started unless PTY
is switched off (“PTY” is not highlighted in
the display).
If necessary, switch off PTY on menu level
2. To do so
• press TU and switch off the function by
pressing the corresponding key.
To start Preset Scan:
• Press SCA for approx. 1 second.
All of the stored stations on the waveband
selected and within reception range will be
scanned one after the other. “SCAN” and
the station name or frequency will flash al-
ternately in the display.
To select a scanned station and switch
off Preset Scan:
• Press SCA or the rocker switch briefly.
Scanning stations with Radio
Scan
You can also scan all of the stations within
reception range.
Radio Scan cannot be started unless PTY
is switched off (“PTY” is not highlighted in
the display).
If necessary, switch off PTY on menu level
2. To do so
• press TU and switch off the function by
pressing the corresponding key.
To start the Scan function:
• Press SCA briefly.
All of the stations on the waveband select-
ed and within reception range will be
scanned one after the other. “SCAN” and
the station name or frequency will flash al-
ternately in the display.
Radio operation with RDS (Radio Data System)
ChicHanKanMonParis gb 95%® 14.05.2002, 14:24 Uhr62