Filter
Top Products
56
• Remove the first KeyCard and insert
the new one while “CHANGE” still ap-
pears in the display.
After the display indicates “READY” or
“LEARN KC”,
• press DSC.
Now you can also use the new KeyCard for
operating your unit.
A maximum of two cards can be used with
the set.
If you attempt “train” a third one, the access
authorisation for the KeyCard not used for
the “training” process will be deleted auto-
matically.
Displaying the radio pass data
You can use the KeyCard supplied with your
set to display the radio pass data such as
the model name, product number (7 6 ...)
and serial number.
Please refer to the section on “DSC pro-
gramming - READ KC”.
Short Additional Memory
(S.A.M.)
The second KeyCard available from your
specialised dealer allows you to read out
short information, which will run through the
display, such as, for example, the phone
number of your car dealer or the emergen-
cy call number of your automobile associa-
tion.
The freely selectable text with a maximum
of 162 characters can be programmed by
any dealer who has the required equipment
available.
Turn On Message (T.O.M.)
The second KeyCard available from your
specialised dealer also allows you to dis-
play a special turn-on message each time
the radio is switched on.
The freely selectable text with a maximum
of 48 characters can be programmed by any
dealer who has the required equipment
available.
Each time you turn on your system with the
second KeyCard, the programmed text will
appear in the display.
Optical display as theft protec-
tion
Flashing light diode ?
When the vehicle is stationary and the Key-
Card has been removed, the light diode can
be switched to flash for extra anti-theft se-
curity.
For this it is necessary that the positive pow-
er supply line and the permanent +12 V lead
are connected such as described in the in-
stallation instructions.
Make sure that the unit is switched off; the
operating panel is unlocked; the KeyCard
has been removed; “LED ON” has been
selected in the DSC mode (factory setting).
If necessary, please refer to the section on
“DSC programming - LED”.
Switching off the flashing light
The flashing light can be switched off by
selecting “LED OFF” in the DSC menu.
KeyCard theft protection system
ChicHanKanMonParis gb 95%® 14.05.2002, 14:24 Uhr56