Filter
Top Products
74
Clock - Time
This car stereo is equipped with a built-in
clock which automatically takes advantage
of RDS to ensure highly accurate time-keep-
ing (hours, minutes).
For the clock to function properly with RDS,
an RDS station with the CT function (CT –
clock time) must be received.
The automatic correction of the time can be
switched off.
Setting the clock
a) automatically
The clock is set automatically when the
radio is tuned into an RDS station
which has the “CT” function (clock
time).
b) manually with DSC-CLOCKSET
• Press DSC briefly, “CLOCKSET” will
appear in the display.
• Press << >> to set the hours/min-
utes. You can move to a different po-
sition by pressing / .
• After you have set the clock, press
ENT briefly to store the new setting.
Displaying the clock
You can set the clock to permanent display
in both the radio and CD modes.
Radio mode:
You can switch between clock display and
waveband (incl. memory bank for FM). To
do so
• press DIS for approx. 2 seconds.
Cassette operation:
You can select from four different display
modes.
To switch to the clock
• press DIS repeatedly until CLOCK ap-
pears in the top line of the display.
Changer operation:
You can select from three different display
modes.
To switch to the clock
• press DIS as often as necessary.
Correcting the clock after the
power has been disconnected
If the radio has been disconnected from its
power source for a longer period of time,
“0:00” will appear in the display when it is
re-connected.
The time will be set automatically by RDS-
CT, but can also be adjusted manually if
desired.
You need only set the time manually if it is
not possible to receive an RDS station with
CT (clock time).
If you want to set the time manually, refer to
the section on “DSC programming - CLOCK-
SET”.
Deactivating the hour correction
function
In the DSC menu it is possible to switch off
the hour correction function with “CLK MAN/
CLK AUTO”. An automatic correction for
minutes will continue to take place.
This is useful if you would like to display the
time for a different time zone, for example.
If necessary,
• Press DSC briefly and
• Press / as often as required until
“CLK MAN/CLK AUTO” appears in the
display.
To deactivate the hour correction function
press << >> to select “CLK MAN”.
ChicHanKanMonParis gb 95%® 14.05.2002, 14:25 Uhr74