Blaupunkt TCM 169 Car Stereo System User Manual


 
83
DEUTSCH
Radio
Telefon
ENGLISH
Radio
Telephone
Manual tuning:
Press << / >>; the frequency will
change in degrees in the downwards
or upwards direction.
If you hold down the right or left part of the
rocker switch, the frequency scan will speed
up in the corresponding direction.
Entering the frequency directly
For FM or FMT, it is possible to enter the
station frequency directly.
Start your entry
by pressing 0.
Then enter the frequency, beginning
with the first digit. You need not enter
a decimal point.
Press CL to cancel this process or OK to
confirm your selection.
Station tuning
Seek tuning /
Press / ; the car radio will automati-
cally search for the next station.
If you hold down / (also applies to re-
mote control operation), seek tuning will
speed up in upwards or downwards direc-
tion.
Seek tuning
Up
Down
<< / >> Up/Down in increments (for FM only
when AF is switched off)
Manual tuning with << / >>
You can also tune in a station manually.
Important:
AF must be switched off (i.e. the “AF” or
“REG” symbol does not light up in the dis-
play).
If necessary, deactivate this function:
Press AF/#.
If you wish to continue listening to the first
programme, switch REGIONAL ON by
pressing AF/# for approximately 1 sec-
ond until “REGIONAL ON” appears in
the first line.
When the regional function has been
switched on “REG” will replace “AF” in the
display.
If you leave the service area of the regional
programme you are currently tuned into, or
if you would like to take advantage of the
full RDS service, switch to “REGIONAL
OFF”.
Press AF/# for approximately 1 second
until “REGIONAL OFF” appears.
Selecting a waveband
You can select between the following wave-
bands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
Use BND to select the waveband.
Press repeatedly if necessary.
Radio operation with RDS (Radio Data System)