Filter
Top Products
101
DEUTSCH
Radio
Telefon
ENGLISH
Radio
Telephone
Using the telephone
All of the telephone functions can be oper-
ated using a trained SIM card.
• With the card tongue protruding, insert
the trained SIM card into the slot with
the contact surface facing up.
• Switch the unit on.
If you have not yet trained any SIM cards,
refer to the section on “Train or delete Key-
Card/SIM card”.
GSM network service area
To be able to use the telephone, you must
be located in an area served by the GSM
network. As soon as a network signal is re-
ceived, the symbol indicating the signal
strength and an antenna symbol will
appear in the display. If the signal is not
strong enough your call may be disconnect-
ed. If the antenna symbol is flashing, it is
possible to make emergency calls only. If
the antenna is displayed on a dark back-
ground, you are located in an area serviced
by a roaming network (may be subject to
additional charges).
Switching to telephone mode
It is possible to switch to the telephone mode
from any of the audio modes.
• Press .
The display will indicate the network and the
network operator if a network signal is re-
ceived. The antenna symbol will not flash.
Save telephone numbers and
names
You can save up to 25 telephone numbers
and names (entries) in the telephone mem-
ory bank.
The number of entries you can save on the
SIM card depends on the type of card you
use.
If you would like to save an entry, press the
following keys one after the other:
• Press ME on the set for approx. 1 sec-
ond.
• Press
/ to choose the entry posi-
tion, for example:
“SIM card” or “Phone” and press OK.
• Enter the new telephone number and
press OK.
• Use the selection buttons to enter the
name. If necessary, refer to the section
on “How to enter a name/text”. Press
OK to confirm your entry.
• Enter the entry position and press OK.
If you do not enter a position, the entry will
be stored at the next available position.
If there is a number already stored at the
position entered, “Overwrite ?” will appear
in the display.
Press OK to overwrite the entry (the previ-
ous entry will be deleted).
Add the next entry:
• Press OK.