Filter
Top Products
88
Listening to the radio while fast
forwarding/rewinding the tape
with RM (Radio Monitor)
While fast forwarding or rewinding the tape,
you can listen to the radio instead of the
usual muting (also applies for S-CPS).
The “RAD. MONITOR ON” setting must be
activated in DSC mode.
Refer to “Programming with DSC – RAD.
MONITOR” if necessary.
Care instructions
You should use only C60/C90 tape cas-
settes in your car. Protect your cassettes
against dirt, dust and temperatures over
50 °C. Allow cold cassettes to warm up
somewhat before playing them to ensure
that the tape plays smoothly. Malfunctions
in playback or sound may be caused by dirt
build-up on the pinch roller and the audio
head after approx. 100 hours of operation.
To remove normal dirt build-up clean the
equipment with a cleaning cassette. In more
stubborn cases, use a cotton swab dipped
in rubbing alcohol. Never insert hard instru-
ments into the tape deck.
Tape equalisation
The unit is able to identify the following tape
types: iron oxide, chrome oxide or metal; it
will switch to the corresponding setting au-
tomatically.
When metal or chrome cassettes are played
“MTL” will light up in the display.
Dolby B NR*
This equipment is able to play back cas-
settes which have been recorded using Dol-
by B NR or without noise reduction.
There is far less tape noise and the sound
dynamics are correspondingly greater on
cassettes recorded using Dolby NR*.
“DOLBY” will light up in the display when
Dolby B NR is switched on.
Switching on/off:
• Press
.
* Noise reduction system manufactured under licence
by Dolby Laboratories. The word Dolby and the dou-
ble-D symbol are trademarks of Dolby Laboratories.
Operating the cassette deck