Classe Audio CAP-2100 Car Amplifier User Manual


  Open as PDF
of 46
 
16
Classé has gone to extraordinary effort to ensure that the single-ended
(RCA) outputs of your integrated amplifier are as good as possible.
If you need to use these preamplifier-level outputs, connect these single-
ended outputs to an amplifier using high-quality shielded RCA-terminated
cables. Your Classé dealer can advise you on the selection of cables suitable
for your system.
3 Tape output
Connect these outputs to the right-channel and left-channel recording
inputs of your recorder.
ese single-ended RCA outputs are unaffected by the volume control
on the front panel, or by whether you choose to monitor the source or
the recorder (by having the “tape” button on the front panel’s touchscreen
deselected or selected, respectively). e record outputs will be disconnected
when the integrated amplifier is placed into standby, however.
4 Tape Input
Connect the analog outputs of any recording device (analog tape recorder,
digitaltaperecorder,CDrecorder,etc.)youmayhavetothesesingle-ended
RCA inputs. You may select to hear the output of your recording device by
touching the tape monitor button on the main operational screen of the
CAP-2100.
5 Single-ended (RCA) inputs
ese RCA jacks accept right-channel and left-channel (single-ended)
inputsfromline-levelsourceequipmentsuchastuners,CDplayers,
and tape decks. Any of these inputs may be selected by touching the
corresponding button on the main operational screen of the front panel
touchscreen.
Toachievethebestpossibleresults,wesuggestthatyouuseonlyhigh-
quality shielded interconnect cables. Please consult with your local Classé
dealer for advice on the best cables for use in your system.
optional phono preamp If you have a turntable you would like to use with the system, an optional
phonopreampliermoduleisavailablefromyourClassédealer.Once
installed in your integrated amplifier, the Line 1 input connectors become
your phono inputs, and the phono gain control in the menu system
becomes active, allowing you to select either low gain for all moving-
magnet (MM) and high-output moving-coil (MC) cartridges, or high gain
for standard output MC cartridges. (See the section e Menu System for
more information.)
6 Balanced (XLR) input
ese XLR jacks accept right-channel and left-channel balanced signals
from a source component with balanced outputs. is input may be
selected by touching the corresponding button on the main operational
screen of the front panel touchscreen.
 previous next