Classe Audio CAP-2100 Car Amplifier User Manual


  Open as PDF
of 46
 
43
Specifications
All specifications are accurate at the time of printing. Classé reserves the right to
adjust specifications without notice.
n Power output (both channels driven) 100W/chcontinuousrms@8W
200W/chcontinuousrms@4W
n Frequency response 10Hz–22kHz(+0/-0.1dB)
10Hz–155kHz(+0/-3.0dB)
n Phase lessthan-10°@22kHz
n Signal-to-noise ratio 95dB typical
n Channel separation betterthan95dB@20kHz
n Noise floor (FFT) allpeakslessthan-90dBV
(10Hz–80kHz)
n Distortion (THD + noise) 0.005%@8W
(unweighted, 0.8Vrms/1kHz input, 10Hz – 80kHz)
n Maximum input voltage 3.8Vrms(single-ended)
7.8Vrms(balanced)
n Voltage gain range -100dB to +14dB
n Sensitivity (SSP input) 0.5Vrmsforratedoutput(single-ended)
 1.0Vrmsforratedoutput(balanced)
n Input Impedance 100kW
n Output Impedance (main output) 100W
n Input complement 1 balanced (XLR), 4 single-ended (RCA)
n Output complement 2 single-ended (RCA)
n Crosstalk (any input to any output) better than -95dB
n Rated power consumption (as per IEC60065 - para.2.3.10) 260W
n Idle power consumption 125W
n Mains voltage specified on rear panel decal
(cannot be changed by user or dealer)
n Dimensions (not incl. controls or connectors) Width: 17.5” (445mm)
Height: 4.75” (121mm)
Depth:16.5”(419mm)
n Shipping weight 59lbs (27kg)
n Net weight 50lbs (23kg)
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
CanadaH8T1B3
Telephone +1(514)636-6384
FAX +1 (514) 636-1428
Internet: http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX®isaregisteredtrademarkofAMXCorporationofRichardson,TX.Allrightsreserved.
Crestron™isatrademarkofCrestronElectronics,Inc.ofRockleigh,NJ.Allrightsreserved.
 previous next