Filter
Top Products
2-Way RF Compact Color Touchpanel Crestron STX-1550C
BACKLIGHT TIMEOUT is displayed on the Timeout screen. This setting turns
the backlight off when the touchpanel is inactive for the specified time (shown in
minutes). When the touchpanel is activated, the last screen to be displayed reappears.
A two minute BACKLIGHT TIMEOUT is shown in the diagram. Minutes can
vary from 0 to 120, where 0 disables the timeout. The DOWN and UP buttons
decrease and increase the timeout, respectively.
NOTE: Power Down Timeout should be set low to maximize battery life. However,
Power Down Timeout should be set greater than Standby Timeout. Otherwise, the
Standby Timeout is never reached.
NOTE: The purpose of the Power Down Timeout is to maximize battery life. If the
external power pack is attached to the touchpanel and plugged into an active AC
receptacle or if the touchpanel is resting in the docking station (ST-DS) and plugged
into an active AC receptacle, the panel does not power down when the power down
timeout is achieved. Standby timeout still functions.
After timeout parameters have been set, touch the SAVE TIMEOUTS button in the
lower left corner of the screen to save the new settings. Touch the RETURN button,
located in the bottom right corner of the screen, to display the Setup Menu.
Interface Screen
Interface Submenu
The touchpanel communicates with a control system to activate other controls or to
display feedback from components within the system. The communication interface
must be correctly specified or communication will not occur. To set communication
parameters select the INTERFACE button located in the upper left corner of the
Setup Menu to display the Interface Menu, shown to the left.
The NET ID is represented by # # for illustrative purposes on the Interface Menu.
NET ID is the two-digit hexadecimal number that can range from 03 to FE and must
correspond to the NET ID set in the Crestron Viewport via SIMPL Windows or VT
Pro-e software. Matching NET IDs between the STX-1550C touchpanel and a VT
Pro-e program is required if new touchpanel screens are to be loaded. Matching NET
IDs between touchpanels and a SIMPL Windows program is required if data is to be
successfully transferred. The NET ID of each STX-1550C is factory set to 03.
Two side-by-side buttons, < CRESNET ID and CRESNET ID >, decrease and
increase the NET ID by one, respectively.
The touchpanel usually communicates with a Cresnet system. Occasionally the
touchpanel can be used in a local demo mode where it merely displays various
menus, but does not communicate with the Cresnet system. In local mode, the
directory buttons change pages, but buttons requiring feedback do not work. Two
buttons on the Interface Menu, CRESNET II and LOCAL, determine
communication mode. Select CRESNET II for normal Cresnet communication
mode or LOCAL to set the touchpanel into demo mode. Text within the selected
button changes color from black to red and the communication mode is factory set to
CRESNET II.
8 • 2-Way RF Compact Color Touchpanel: STX-1550C Operations Guide - DOC. 5812A