Filter
Top Products
Crestron STX-1550C 2-Way RF Compact Color Touchpanel
RF Settings Screen
NOTE: Do not set the RF ID to “0”; it is not supported in SIMPL Windows.
The RF SETTINGS button opens the RF SETTINGS screen, shown to the left. The
RF ID is displayed in the RF SETTINGS screen. The RF ID must match the identity
code in the SIMPL Windows program and is identified by a hexadecimal number in
the range from 0 to F. In the diagram, the RF ID is shown with a setting of “01”. The
DOWN and UP buttons associated with the RF ID field decrease and increase the RF
ID by one, respectively.
NOTE: Due to network traffic, the STX-1550C may not respond to a network
upload. To compensate, access the setup screens (refer to “Configuring the
Touchpanel” on page 6) to provide exclusive upload communication between the
touchpanel and the control system.
The RF CHANNEL of the touchpanel
must be identical to the RF
CHANNEL of the STRFGWX(s) to
which it communicates. The same
channel may be used for more than
one STRFGWX when used to expand
the roaming capabilities of a
touchpanel within any particular
area(s) or installation.
The RF CHANNEL is displayed in the RF SETTINGS screen. The RF CHANNEL
is identified by a hexadecimal number in the range from 0 to F. In the diagram, the
RF CHANNEL is shown with a setting of “F”. The DOWN and UP buttons
associated with the RF ID field decrease and increase the RF ID by one,
respectively.
The TEST button should only be used under supervision from a Crestron customer
service representative during telephone support. The options available from the
TEST Menu are beyond the scope of this guide.
Select the RETURN button after interface parameters have been set.
Sound Screen
Sound Submenu
The SOUND button, located at the top right corner of the Setup Menu, is used to
display the Sound Menu, shown to the left. Use this screen to activate audible key
clicks. This feature is a useful feedback tool. Confirmation of a button press on a
touchpanel is acknowledged by an audible click assuming this feature is enabled. To
enable this feature, verify that the KEYCLICK ON button is active (red). An active
KEYCLICK OFF button disables the feature. Volume of the audible click is
controlled with the VOLUME UP and VOLUME DOWN buttons. The unit is
factory set with the sound on.
Uploading and Upgrading
To upload a VT Pro-e project or upgrade the firmware of the STX-1550C, a local PC
that contains the Crestron Viewport (available in SIMPL Windows or VT Pro-e) is
required. Refer to the following sections.
Hookup and Preparation
To prepare the STX-1550C for uploading or upgrading, refer to the figures shown on
the next page for typical connection diagrams. Complete the following steps
provided to ensure proper connection to the system.
NOTE: The components in the second figure on the next page are part of the
SmarTouch Programming Kit (ST-PK). If available, use these components.
Operations Guide - DOC. 5812A 2-Way RF Compact Color Touchpanel: STX-1550C • 9