Filter
Top Products
2-Way RF Compact Color Touchpanel Crestron STX-1550C
Physical Description
The touch-sensitive viewing screen is located on the top of each touchpanel. The
electronic hardware is housed in a high impact, black molded plastic enclosure, shown
below. Connectors to upload touchscreen projects via a personal computer (PC) and to
power the unit using the external power pack are located on the left and right sides of
the unit, respectively.
Physical Views of STX-1550C
5.70 in
(14.48 cm)
CRESTRON
8.75 in
(22.23 cm)
3.33 in
(8.45 cm)
5.01 in
(12.73 cm)
REFERENCE
UPLOAD
CONNECTOR
POWER
CONNECTOR
At the underside of the unit is the battery compartment that holds one ST-BTP.
Contacts for the ST-DS are through the ST-BTP. There are also four rubber feet on
the underside of the unit for stability and to prevent slippage.
Software
Have a comment about
Crestron software? Direct software
related suggestions and/or complaints
to Crestron via email
(software@crestron.com).
Do not forward any queries to this
address. Instead, refer to “Further
Inquiries” on page 23 for assistance.
When part of a SmarTouch system, the STX-1550C is supported by the
VisionTools™ Pro-e (VT Pro-e) SmarTouch Wizard that automatically configures
the entire system and the touchpanel pages. VT Pro-e, a design and programming
Windows®-based software, permits the creation of unlimited control screen
variations incorporating two and three-dimensional graphics and text. A set of pages
which make up a project can be designed for each touchpanel application. Each page
contains objects such as custom control graphics, two and three-dimensional buttons,
sliders, and digital readouts which allow the user to interface with the Cresnet
system. The project is uploaded to the touchpanel and programmed into the flash
PROM. The touchpanel uses the programmed project until another set is uploaded
from the PC. The PC may be disconnected from the rack or panel except during
reprogramming. VT Pro-e also allows users the option to generate projects destined
for web browsers rather than for physical touchpanels.
For additional software information, refer to the help file provided with the software.
A copy of the software can be obtained from the What’s New page (VisionTools
Pro-e section) or Downloads page (TOUCHPNL Library) of Crestron’s website
(www.crestron.com)
. New users are required to register in order to obtain access to
the FTP site. A tutorial is provided as a guide for the novice programmer.
2 • 2-Way RF Compact Color Touchpanel: STX-1550C Operations Guide - DOC. 5812A