Hyundai H-CMD4015 Car Video System User Manual


 
5
Installation/connection
Notes:
 Choose the mounting location where the unit will not interfere with the normal driving function of the
driver.
 Before finally installing the unit, connect the wiring and make sure that the unit works properly.
 Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the
vehicle.
 Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden
stop, like an emergency stop.
 If installation angle exceeds 30° from horizontal, the unit may not perform properly.
 Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or
from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
Din Front/Rear-Mount
This unit can be properly installed either from 'Front' (conventional DIN Front-mount) or 'Rear' (DIN Rear-
mount installation, utilizing threaded screw Holes at the sides of the unit chassis). For details, refer to the
following illustrated installation methods.
Remove the mechanism transit screw before installation
Before install the unit, must remove the two screws with label "REMOVE SCREW".
1. DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any dashboard having an opening as shown below (DIN standard):
Installing the unit
Be sure you test all connections first, and then follow these steps to install the unit.