Filter
Top Products
7
9. To further secure the unit, use the supplied metal strap
to secure the back of the unit in place. Use the supplied
hardware (Hex Nut (M5mm) and Spring Washer) to
attach one end of the strap to the mounting bolt on the
back of the unit. If necessary, bend the metal strap to fit
your vehicle's mounting area. Then use the supplied
hardware (Tapping Screw (5x25mm) and Plain Washer)
to attach the other end of metal strap to a solid metal part
of the vehicle under the dashboard. This metal strap also
helps ensure proper electrical grounding of the unit.
Ensure that you install the short part of the mounting bolt
to the back of the unit and the other long part to the
dashboard.
10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install
the unit's front panel.
Dismantling the unit
1. Make sure the ignition is turned off, and then disconnect the
cable from the vehicle battery's negative (-) terminal.
2. Press RELEASE button to remove the front panel.
3. Lift the top of the outer trim ring then pull it out to remove it.
4. Insert both of the supplied keys into the slots at the middle left
and right sides of the unit then pull the unit out of the dashboard.
5. Remove the metal strap attached to the back of the unit (if
attached).