Filter
Top Products
6
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-)
terminal.
2. Disconnect the wire harness and the antenna.
3. Press RELEASE button to remove the control panel.
4. Lift the top of the outer trim ring then pull it out to remove
it.
5. Use the two supplied release keys to remove the unit from
the mounting bracket. Insert the left ("L") and right ("R")
release keys as far as they will go (with the notches facing
up) into the appropriate slots at the middle left and right sides
of the unit. Then slide the sleeve off the back.
6. Mount the sleeve by inserting the sleeve into the opening
of the dashboard and bend out the tabs located around the
sleeve with a screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most effective. To
secure the sleeve in place, bend out the appropriate tabs so
that they make contact with the dashboard.
7. Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.
8. Slide the unit into the sleeve until it locks into place.