Filter
Top Products
HD5212
~
Menu
Operation
Press and hold the rotary encoder (4) to access the system menu.
Repeatedly press the rotary encoder button to access menu options
in
the
following order:
BEEP ON/OFF: The beep tone feature allows the selection
of
an
audible beep tone to
be
heard each time a button
is
pressed on the face
of the radio. "BEEP ON"
is
the default display. Rotate the rotary encoder
to select the "BEEP OFF" option.
P--VOL: Turn the rotary encoder to select the default volume the radio
will assume when first turned
on.
PClK
ON/OFF: When "ON", the clock and backlight will remain
on
when the unit
is
turned off.
PRI
ClK/SRC:
Select
"ClK"
to have the clock appear on the display
during playback. Select "SRC" to have the current source appear during
playback. Press the DISP button (7) to temporarily view the alternate
display (clock or source) temporarily.
HOURS 12/24: This option allows selection
of
a
12
hour or 24 hour
clock format. "HOURS 12"
is
the default setting. Turn the rotary encoder
to change to the 24 hour clock format.
S--MODE NORMALlHD SEEK (adjustable only
in
RADIO mode):
Select "NORMAL" to allow the radio to search for both digital and
analog stations. Select "HD SEEK" to only search and broadcast digital
stations.
Equalizer
Press the
EQ
button (20) to choose one
of
the following pre-defined bass
and treble curves:
FLAT>
CLASSICS> POP M > ROCK M > DSP
OFF.
Loudness
Press
and
hold the
BAND
button (3) toggle loudness on/off. When listening
to music at low volumes, this feature will boost the bass and treble ranges
to compensate for the characteristics
of
human hearing.
Auxiliary
Input
To
access
an
auxiliary device:
1.
Connect the portable audio player to the AUX
IN
jack
on
the front panel
(12).
2.
Press the SRC button (2) to select AUX mode.
3.
Press SRC again to cancel AUX mode and go to the next mode.
9
Setting
the
Clock
If not already showing, press the DISP button (7) to display the clock. With
the clock displayed,
press
and
hold the DISP button and the time will flash
on the display. Press the TUNE/CH
» button (10) to adjust the hours or the
TUNEICH
« button
(11)
to adjust the minutes. When
in
"HOURS 12"
mode, "AM" or "PM" will appear on the display to indicate
AM
or PM. When
no adjustment
is
made for five seconds, the time will become set and
normal operation will resume.
Front
Panel
Release
The.
(open) button (9) releases the mechanism that holds the front panel
to the chassis.
Detaching the
Front
Panel
To
detach the front panel, first
press
the.
(open) button and
allow the front panel to swing
down. Grasp the right side
of
the front panel and push
it
to
the left and then pull to release
the right side. Remove the
front panel and store
it
in
the
supplied carrying case.
Re-attaching the
Front
Panel
To
re-attach the front panel,
make sure the electrical
terminals
on
the back
of
the
panel are free of dust and dirt,
as debris could cause
intermittent operation or other
malfunctions. With the panel
in
the open position, slide the left
side of the panel
in
place so
that it is correctly engaged,
then lightly press the right side
of
the panel until it locks into
place. Lift to close.