Filter
Top Products
~
HD5212
REMOVAL KEYS
y~~.:.~
,,:
.....
_.-:.y,~.
o
Removing
the
Radio
To
remove the radio after installation,
remove the trim ring by pulling outward
on one side and then the other. Insert
the removal keys straight back, with the
notches facing up, until they lock. With
the removal keys engaged, pull the
radio straight out. If removal keys are
inserted at
an
angle, they will not lock
properly to release the unit.
Connecting
the
Satellite
Radio
Receiver
(optional)
Before you can listen to satellite radio, you must install the satellite receiver
and antenna (purchased separately). The satellite radio receiver is the
central data receiving equipment required to process the satellite signals
from the external antenna.
It
is typically installed
in
the dash, under the seat,
or
in
the trunk or rear
of
the vehicle. Do not mount receiver near a heater
vent or where it can be exposed to extreme temperatures.
In
addition, when
running the wire for the external antenna do not kink or pinch the antenna
cable. A sharp 90 degree bend
or
slight "nick" to the outer cable sheath will
cause signal degradation. The wiring diagram will help you identify the
proper connections.
Technical
Assistance
If you require assistance, contact Technical Support at 1-800-323-4815
from 9:00am to 6:00pm EST Monday through Friday.
6