Filter
Top Products
HD5212
~
9.
Attach one end
of
the perforated support strap (supplied) to the screw
stud
on
the rear
of
the chassis using the hex nut provided. Fasten the
other end of the perforated strap to a secure part
of
the dashboard
either above or below the radio using the tapping screw and washer
provided. Bend the strap, as necessary, to position it. CAUTION: The
rear of the radio must
be
supported with the strap to prevent damage to
the dashboard from the weight
of
the radio or improper operation due to
vibration. The strap also ensures proper electrical grounding
of
the unit.
10. Re-attach the front panel to the chassis and test radio operation by
referring to the operating instructions for the unit.
NOTE:
For
proper
operation
of
the
CD
player, the
chassis
must
be
mounted
within
2(1'
of
horizontal. Make
sure
the
unit
is
mounted
within
this limitation.
ISO
Installation
This unit has threaded holes
in
the chassis side panels which may
be
used
with the original factory mounting brackets
of
some vehicles to mount the
radio to the dashboard. Please consult with your local car stereo shop for
assistance
on
this type of installation.
1.
Remove the existing factory radio from the dashboard or center console
mounting. Save all hardware and brackets as they will be used to mount
the new radio.
2.
Carefully unsnap the plastic frame from the front
of
the new radio
chassis. Remove and discard the frame.
3.
Remove the factory mounting brackets and hardware from the existing
radio and attach them to the new radio using the same screws. Do not
exceed M5 x 9 MM maximum screw size. Longer screws may damage
components inside the chassis.
4.
Wire the new radio to the vehicle as outlined
in
the Universal Installation
instructions.
5.
Slide radio chassis into dash opening and secure with factory radio
screws.
6.
Reinstall dash panel
5
ISO INSTALLATION
Kit
Installation
If
your vehicle requires the use
of
an installation kit to mount this radio,
follow the instructions included with the installation kit to attach the radio to
the mounting plate supplied with the kit.
1.
Wire and test the radio as outlined
in
the Universal Installation instruc-
tions.
2.
Install the radio/mounting plate assembly to the sub-dashboard
according to the instructions
in
the installation kit.
3. Attach the support strap to the radio and dashboard as described
in
the
Universal Installation instructions.
4. Replace the dashboard trim panel.
Fuses
When replacing a fuse, make sure the new fuse is the correct type and
amperage. Using an incorrect fuse could damage the radio. The HD5212
uses one 15 amp fuse located below the wiring connector (15 amp fast blow
ATO).
Reconnecting
the
Battery
When wiring is complete, reconnect the battery negative terminal.