Filter
Top Products
English
|
7
Function setting Operation
The basic operating procedure for using this
function is described below. The individual function
items are covered in the operating procedures.
1
Select the source
Press the [SRC] button.
Function items vary from source to source.
2
Enter Function setting mode
Press the [VOL] knob.
3
Select the setting item
Turn the [VOL] knob and press it when the
desired item is displayed.
Repeat the operation until your desired setup item
is selected.
Operation example:
[VOL] [ ]
[VOL] [ ]
Settings
Seek Mode
Auto Memory
…
Audio Control
…
1 1
2
4
3
1 3
2 4
1 sec.
Exit
In this manual, the above selection is indicated as
Select “Settings”/ “SETTINGS”
> “Seek Mode”/
“SEEK MODE”.
4
Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
5
Exit Function setting mode
Press the [ ] button for at least 1 second.
Common Operation
Power and source select
Turns the power ON by pressing the [SRC]
button.
When the power is ON, select a source.
Press the [SRC] button each time switches
between sources.
Tuner (“TUNER”) ➜ USB (“USB”) or iPod (“iPod”)
(DPX-U6120/ DPX-U5120 only) ➜ CD (“CD”) ➜
Auxiliary input (“AUX”) ➜ Standby (“STDBY”/
“STANDBY”) ➜ Tuner...
DPX-U6120 DPX-U5120
Press the [iPod] button to switch the source to
iPod.
Press the [SRC] button for at least 1 second to
turns the power OFF.
⁄
• The SRC Select mode can be set in “Source Select” of <Initial
Settings> (page 30). (DPX-U6120 only)
• When an optional accessory is connected, the source name
for each device appears. (DPX-U6120 only)
• When connection of the iPod is recognized, the source
display changes from “USB” to “iPod”.
Volume
Turning the [VOL] knob adjusts the sound
volume.
B64-4805-00_01_DPXU6120_M_en.indd 7 11/02/02 15:07