Filter
Top Products
23
Basic section
TAPE EQ.
TAPE EQ.
STOP
7
T
0000
A
PE STOPRWE
T
0152
A
PE PLAYRWE
menu
down
volume/
multi control
up
down
volume/
multi control
up
set/demo
set/demo
Playback of tape
To wind tape at high speed
÷ Press the 7STOP key to stop fast winding.
To fast wind in
direction |
To fast wind in
direction \
Selection of TAPE equalizer (TAPE EQ.)
(Remote control unit only)
When playing a tape prerecorded with Noise Reduc-
tion system (such as the DOLBY NR) ON, be sure to
set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 “TAPE EQ.” ON TAPE equalizer is used.
2 “TAPE EQ.” OFF TAPE equalizer is not used.
Lit when “TAPE EQ.” is ON
÷ Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
÷ Normal (TYPE
), high (TYPE ), or metal (TYPE ) tape
selection is set automatically.
÷ Remove tape slack before loading.
To stop playback
Selection of reverse mode
(Main unit only)
Reverse mode indication
Displayed when the deck is loaded with a tape.
1Select “TAPE RVS. ?”.
2 Select.
3 Set it.
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the 2 tape transport indicator is lit). To set the tape
counter to “0000”, open the cassette holder once. Then
the counter will be reset.
1
“ ” : (REVERSE)
Both sides are played back (recorded), and then the
tape stops.
2
“ ”:(ENDLESS)
Both sides are played back endlessly.
(The tape stops after recording onto both sides.)
3
“ ”: (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
(Press the set/demo key while the “?” mark
is blinking.)
(The initial setting is "
" (REVERSE).
4¢
Tape counter
Do not use a cassette with more than 90-minute re-
cording time, for the tape used with such a cassette
is very thin and tends to cause troubles such as en-
tanglement around the pinch roller or cutting of
tape.
Transport direction indicators