Filter
Top Products
42
Application section
2
3
1
STOP
7
menu
down
volume/
multi control
up
set/demo
Twin recording onto MD and tape
(TWIN REC)
(Main unit only)
All the tracks on a CD can be recorded simultaneously onto an MD and tape. (All-track twin recording)
The current track can be recorded from the beginning simultaneously onto an MD and tape. (single-
track twin recording)
Convenient Recording Methods
Make the preparations for recording.
1 MD : Insert a disc into the MD recorder.
TAPE : Perform steps 1 to 3 of the procedure in ”Recording on TAPE”.
º
2 Insert disc in the CD player.
Be sure to put the MD recorder and cassette deck in stop mode.
Check the current play mode of the CD player.
Start recording.
All-track twin recording Single-track twin recording
To record other tracks using ”Single-track twin re-
cording”, repeat steps 2 and 3 for each track.
If it is in play mode, stop it.
1 Select ”REC MODE ?” then
”TWIN REC ?”.
2 Start recording.
To interrupt a recording
(Recording and playback will be
stopped.)
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
÷ With single-track simultaneous recording, when the set/
demo key is pressed, the “MD REC” and “TAPE REC”
indicators light and recording starts by returning to the
beginning of the current track.
Turning the knob switches the display contents.
1 CD=MD<NORM> ?
2 CD=MD<HIGH> ?
3 CD=TAPE ?
4 TWIN REC ?
STOP
7
Select the desired CD track and play it. &
Note that this cassette deck cannot record onto
Metal tapes.
Note
Note
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.