Filter
Top Products
Application section
56
MD Edit Functions
TITLE
INPUT
P.CALL
SET
ENTER
TITLE
INPUT
TITL
E
INPUT
......
.
]
1
[
Entering characters in title memo (TITLE MEMO)
1 Press the TITLE INPUT key while the
MD recorder is in stop mode.
2 Select the save destination title memo
([1], [2] or [3]).
3 Enter characters as described in proce-
dure step 2 of "Assigning a title to a
disc or track".
4 Press the ENTER key to copy the char-
acters in the title memo.
5 Press the TITLE INPUT key to complete
editing.
÷ To cancel TITLE MEMO in the middle, press the TITLE
INPUT key on the remote.
÷ To enter characters in other title memos, repeat steps 2
to 4 for each character set.
Copying title memo contents as the title of another disc or track
Step 2 Select a disc or track title as the des-
tination in place of the title memo.
Step 5 Select a title memo 1 to 3 as the copy
source.
This editing operation is available by exchang-
ing the parties (copy destination and copy source)
in the procedure of "Copying a Disc or Track Title
in a Title Memo (TITLE COPY)". T
After performing steps 1 to 6 in the procedure
on page 55, change steps 2 and 5 as shown
below. The input can be repeated by simply per-
forming these two steps.
8 Press the 0 MD key and eject the MD.
0
MD
Always eject the MD after title entry or editing.